Eddy currents are loops of electric current induced within conductors by a changing magnetic field in the conductor, due to Faraday's law of induction.
In a transformer core eddy currents are produced which heats up the core and also causes losses by distorting the main current. If the core were a single piece its area would be high, and hence low resistance which causes a larger current to flow increasing the losses.
If laminations are provided the area is reduced and hence resistance is very high which limits the current to a minimum value. The sum of current in all laminations would be still less than the case when a core was used.
Material Property: CRGO&CRNGO
Material Brand: Baosteel, NSC, JFE, TKS, POSCO, NLMK
Material Thickness: 0.05mm, 0.08mm, 0.1mm, 0.23mm, 0.27mm, 0.3mm, and 0.35mm.
Certificate: RoHS 2011/65/EU
Technics: tape winding
Products Frequency: 50-5K HZ
Products Shapes: C E O & Customized
Mechanical Properties: low power loss per cycle / low core loss / high permeability
Application: transformer, sensor and magnetic components of electronic equipment; Automobile Sensor, Solar Inverter, Smart Home
Welding | Spot welding is firm and smooth, and does not weld through two layers |
Winding | winding is tight, the start and end of the sheet can not be turned up |
Planeness | surface unevenness is less than 0.1mm |
Fineness | No crystalline fine particles (no crystalline fine particles on the cut surface) |
Cut face | No obvious crack on the cutting face (no light transmission and peeling between layers) |
Surface | Visually without burrs, rust, or deformation (to control deformation within tolerances) |
Products | Do not contain Pb\Cd\Hg\Cr\PBBs\PBDEs |